Lexmark XM3150 Uživatelská příručka stáhnout pdf (Strana 215)

Use To

On Reduce printer noise.

Notes:

• Print jobs are processed at a reduced speed.

• Printer engine motors do not start until a document

is ready to print. There will be a short delay before

the first page is printed.

Off Use factory default settings.

Note: This setting supports the performance

specifications of the printer.

3 Click Submit.

Adjusting Sleep mode

1 From the home screen, navigate to:

> Settings > General Settings > Timeouts > Sleep Mode

2 In the Sleep Mode field, select the number of minutes the printer is idle before it enters Sleep mode.

3 Apply the changes.

Using Hibernate mode

Hibernate is an ultra‑low‑power operating mode.

Notes:

• Three days is the default amount of time before the printer enters Hibernate mode.

• Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long press of

the Sleep button wakes the printer from Hibernate mode.

• If the printer is in Hibernate mode, then the Embedded Web Server is disabled.

1 From the home screen, navigate to:

> Settings > General Settings

2 From the “Press Sleep Button” or “Press and Hold Sleep Button” menu, select Hibernate, and then touch Submit.

Setting Hibernate Timeout

Hibernate Timeout lets you set the amount of time the printer waits after a print job is processed before it goes into a

reduced power state.

Using the Embedded Web Server

Open a Web browser, and then type the printer IP address in the address field.

Saving money and the environment 215

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 345 346

Žádné komentáře

Lexmark XM3150 Uživatelská příručka Strana 215